Clarity check
Plays a short test sound and listens with the microphone to tell you whether your speaker sounds clear or still muffled.
Water eject app for iPhone
Got your iPhone wet? Speaker Rescue removes water from your phone speaker by playing tones that push it out of the grille, then uses the microphone to check that the sound is clear again.

Three steps, about a minute. Most splashes clear in one or two rounds.
Turn the volume all the way up and disconnect headphones or Bluetooth so the sound plays from the iPhone speaker.
Hold your iPhone with the speaker facing down so gravity helps the water drain out of the grille.
Speaker Rescue plays low tones that push the water out, then checks with the mic that the sound is clear.
Other water eject apps play a tone and hope. Speaker Rescue measures the result.
Plays a short test sound and listens with the microphone to tell you whether your speaker sounds clear or still muffled.
Check before cleaning and again after, and see how much clearer your speaker sounds side by side.
Runs cleaning rounds and checks the sound after each one, stopping as soon as your speaker is clear.
Play any frequency from 20 to 1000 Hz to test your speaker or find the tone that works best for you.






Cleaning the speaker is one part of it. These steps help protect the rest of your iPhone.
Unplug the phone and wait until the Lightning or USB-C port is completely dry before charging. Charging with liquid in the port can corrode the contacts. If iPhone shows a liquid detected alert, wait at least 30 minutes before trying again.
Putting a phone in a bag of rice does not dry it faster, and small grains and starch dust can get into the ports. Apple specifically recommends against it.
Tap the phone gently against your hand with the port and speaker facing down, then leave it in a dry place with some airflow. Don't use a hair dryer, an oven or compressed air, and don't push cotton buds into the openings.
IP67 and IP68 ratings are measured in fresh water under lab conditions, and the seals wear over time. Salt water, chlorine, soap and hot water are harder on them, and liquid damage is not covered by Apple's warranty. Rinse off salt water with fresh water, then dry.
If sound is still muffled, crackling or silent after a day of drying and a few cleaning rounds, or the camera fogs up, the screen behaves oddly or the phone gets warm, have it checked by Apple or an authorised repair provider.
Turn the volume all the way up, hold the phone with the speaker facing down and tap Eject water. Speaker Rescue plays low-frequency tones that make the speaker move and push trapped water out through the grille. Then run a clarity check to confirm the sound is clear.
Yes, for water sitting in the speaker grille, which is what makes sound muffled after a swim or a splash. Sound at the right frequency vibrates the speaker strongly enough to move water droplets out. It cannot fix water damage inside the phone or a broken speaker.
Speaker Rescue costs $2.99 once. There are no ads, no subscription and no in-app purchases, and you can reinstall it on any iPhone signed in with the same Apple ID.
No. The cleaning tones stay within the frequency range your iPhone speaker is designed to play, and each round runs for a limited time. Auto clean stops as soon as the clarity check shows the sound is clear.
No. The microphone is used only during a clarity check, the sound is analysed on your iPhone, and nothing is recorded, stored or uploaded. The app does not connect to the internet.
More answers on the Speaker Rescue support page.
The microphone is used only while a clarity check is running. The sound is analysed on your iPhone and nothing is recorded or uploaded. The app has no ads, no analytics and no tracking, and it doesn't need an internet connection.